Purpose:

This quick guide provides the steps to connect your H200 and also what to expect when it is performing its initial upgrade (using a pre-configured USB stick in the article H200 USB upgrade guide linked below).

Steps:

1. Unpack the H200.

2. Connect the HDMI Cable.

3. Insert the USB drive into the slot next to the HDMI cable.

4. Connect the network cable.

5. Connect the Power Cable.

The H200 automatically starts the system update from the connected USB drive with a circle animation and a message showing Installing system update progress.  Following the update, you will see the results and a message indicating that the upgrade was successful.

6. Remove the USB drive from the H200 and unplug and reinserted the power cable.

7. After the H200 has been restarted, you will be able to view the available channels preconfigured in zapper_lineup.json.

Note: If your environment requires the H200 to be assigned a static IP, then follow the guide on how to set a static IP below.

Related Articles:

Setting a static IP for H200 (24.3.2021.R or earlier)

https://help.aminocom.com/hc/en-us/articles/8451498435737-Setting-a-static-IP-for-H200-24-3-2021-3R-or-earlier-

Setting a static IP for H200 (25.3.2022.9R or later)

https://help.aminocom.com/hc/en-us/articles/8451420255001-Setting-a-static-IP-for-H200-25-3-2022-9R-or-later-

H200 USB upgrade guide

Updating the H200 firmware with a USB Image – Amino Support (aminocom.com)

A more comprehensive Quick Start Guide

https://help.aminocom.com/hc/en-us/articles/4404612093081-H200-Quick-Start-Guide